How To Install A Solar Charge Controller

Introduction

This department will go over how to properly set up a basic system. We will make sure to include the inverter, battery, accuse controller, panel and wiring in this set up.

System Gear up

Annotation: When setting up your system, the panels should exist out of the sun or covered for rubber reasons .

First, the battery should be hooked up to the charge controller. Yous could use our tray cablevision or whatever general stranded copper cadre wire to connect the two. Make sure that you lot lead the wire into the battery terminal of the charge controller and friction match the + and – to the battery + and -. Make sure to screw in the exposed wire tightly inside the controller terminal. Then screw on the bombardment rings to the battery. Run into model two.8.1.

Model 2.8.ane

2d, then connect your solar console to your accuse controller. We recommend that y'all connect the adapter kit to your panel first, and then follow the + or – sign coming off of the leads of the panels and lucifer it with the + and – sign on the charge controller. See model ii.8.2.

Be careful at this footstep, considering if the panel is inserted incorrectly, you lot tin have reverse polarity and short the organization causing harm to the panels or controllers

Model 2.8.2

Lastly yous can claw up your inverter to your battery by using battery ring cables and by matching the + to + and – to -.

See model 2.8.three for more installation instructions

Model 2.eight.3

Video Links

https://world wide web.youtube.com/sentinel?five=f36kxSRK0Ik

Literature Link:

https://www.renogy.com/template/files/Picture-Manual.pdf

https://www.renogy.com/template/files/Off-grid-General-Transmission.pdf

Source: https://www.renogy.com/learn-system-setup/

Posted by: smithshord1965.blogspot.com

Share this post